CAN Telemetry and Bus creation

Questions relalting to all engine GEMS ECUs

Moderators:R!C0, JonMan, RickS

Locked
User avatar
RickS
GEMS Engineer
GEMS Engineer
Posts:547
Joined:Thu May 17, 2007 11:38 am
CAN Telemetry and Bus creation

Post by RickS » Tue Apr 14, 2020 1:48 pm

Setting up CAN Telemetry in '80' series GEMS ECUs

The '80' series GEMS ECUs, can have their CAN bus transmissions setup via the GWv4 calibration software. This can be actioned by selecting the 'Telemetry' tab at the top of the GWv4 workspace, once you have opened your calibration and then selecting the 'CAN Telemetry Setup' feature.

This will then display a panel, where you can select the parameters that you wish to put onto the CAN bus, the CAN bus speed and the rate that you want to dispatch the packets of data in their defined arbitration codes. See the attached document for further details....
RX80-CAN Telemetry Setup#2.docx
'80' series CAN Telemetry setup
(75.47KiB)Downloaded 580 times

Locked