Traction Control
Moderators:R!C0, JonMan, RickS
Hi,
I would like to try and take advantage of the traction control I have but have no settings at all other than what is in the manual as guidance.
Do you have any calibrations you could share that have the system working than I can derive my own setting from?
Thanks
I would like to try and take advantage of the traction control I have but have no settings at all other than what is in the manual as guidance.
Do you have any calibrations you could share that have the system working than I can derive my own setting from?
Thanks
Re: Traction Control
I will have a delve in our archive and post anything that I find here.....
Is this for an EM36 or a different ECU..? Also, what version of firmware please...?
BR, RickS
Is this for an EM36 or a different ECU..? Also, what version of firmware please...?
BR, RickS
Re: Traction Control
Hi Rick,
Yes EM36, 01V28.
Thanks
Mark
Yes EM36, 01V28.
Thanks
Mark
Re: Traction Control
Hi again Mark....
I had a search through the 01v28 cals that I have access to and when that came up dry, I had a look through the 00v89, which gave me the same result.
So, going through my O's and S's I cam up with a cal with some settings that look to be able to accomplish the task. I've created (and attached) an EM36 'Aspect' file, with the options and tables that should get you started..
A few notes on the settings.. i) this used Engine acceleration, so the Gear Ratio table will need to be set for your vehicle (EM36 manual explains how), ii) In the attached aspect, only Ignition Cut/Retard and Fuel Cut are controlled. Boost and
Wastegate are not controlled.
If the TC restrictions are too severe, raise the thresholds in the tables and/or lower the values in the Cut/Retard options.
BR, RickS
I had a search through the 01v28 cals that I have access to and when that came up dry, I had a look through the 00v89, which gave me the same result.
So, going through my O's and S's I cam up with a cal with some settings that look to be able to accomplish the task. I've created (and attached) an EM36 'Aspect' file, with the options and tables that should get you started..
A few notes on the settings.. i) this used Engine acceleration, so the Gear Ratio table will need to be set for your vehicle (EM36 manual explains how), ii) In the attached aspect, only Ignition Cut/Retard and Fuel Cut are controlled. Boost and
Wastegate are not controlled.
If the TC restrictions are too severe, raise the thresholds in the tables and/or lower the values in the Cut/Retard options.
BR, RickS
- Attachments
-
- EM36-TC.aspect
- EM36 Traction Control Aspect file
- (32.32KiB)Downloaded 784 times
Re: Traction Control
Thanks Rick, ill have a play.
Regards
Mark
Regards
Mark