DA3 Loger

Post here if you require technical information regarding a GEMS product

Moderators:R!C0, JonMan, RickS

Post Reply
RAB1000
New User
Posts:2
Joined:Thu Jun 09, 2016 7:16 pm
DA3 Loger

Post by RAB1000 » Thu Jun 09, 2016 7:52 pm

I'm looking for info on how to configure the analog inputs on the DA3 for hall-effect wheel speed sensors. Aside from the DA3 spec sheet posted on the site is more info available? A manual maybe?

User avatar
RickS
GEMS Engineer
GEMS Engineer
Posts:547
Joined:Thu May 17, 2007 11:38 am

Re: DA3 Loger

Post by RickS » Mon Jun 20, 2016 2:35 pm

The manual is currently off-line as it's been rewritten but I'll help where I can.
I have attached a Quick-Start guide, which basically gives the Pin-Out and the meanings on the LEDs.

If you have the tech spec, you'll know that Analogue Inputs 1-4, correspond to Speed Inputs 1-4. Depending on what sensor you fit (Temp/Pressure or a speed) this will be configured what you create and upload the logger setup from the GEMS Data Analysis software (available from the GEMS website).

BR, RickS
Attachments
DA3 Quick Start Guide Rev3.doc
DA3 Quick Start Guide
(127.5KiB)Downloaded 708 times

Post Reply