TPS switch

[mark28]

does my TPS signal have to match my TPS TO LOAD please ??

because i can only scale one or there other, if so which one should i use.??

please can somone reply? i starting to get potty with this

mark

[RichA]

Throttle is calculated thus:

Throttle = (TPS raw - TPS min) / (TPS max - TPS min)

Most ECUs also allow you to invert the raw throttle voltage, for throttles that give a high voltage for closed.

TPS to Load, is only used to default a failed primary load sensor, such as MAF or MAP, and is a "limp home" feature.

Rich A

[mark28]

ok great, thank you.

so what your saying when i have scaled my TPS raw it does not matter if any of my other TPS fuctions DONT go up on the scale? As they only go up about 25% up the scale!???? ( This is whats worrying me.)


mark
very greatfull of your help

[RickS]

No your TPS signal does not have to match the tps to load table.
Scale your tps raw and you will be fine.

Hope this helps
Ed