TPS switch
Moderators:R!C0, JonMan, RickS
does my TPS signal have to match my TPS TO LOAD please ??
because i can only scale one or there other, if so which one should i use.??
please can somone reply? i starting to get potty with this
mark
because i can only scale one or there other, if so which one should i use.??
please can somone reply? i starting to get potty with this
mark
Re: TPS switch
Throttle is calculated thus:
Throttle = (TPS raw - TPS min) / (TPS max - TPS min)
Most ECUs also allow you to invert the raw throttle voltage, for throttles that give a high voltage for closed.
TPS to Load, is only used to default a failed primary load sensor, such as MAF or MAP, and is a "limp home" feature.
Rich A
Throttle = (TPS raw - TPS min) / (TPS max - TPS min)
Most ECUs also allow you to invert the raw throttle voltage, for throttles that give a high voltage for closed.
TPS to Load, is only used to default a failed primary load sensor, such as MAF or MAP, and is a "limp home" feature.
Rich A
Re: TPS switch
ok great, thank you.
so what your saying when i have scaled my TPS raw it does not matter if any of my other TPS fuctions DONT go up on the scale? As they only go up about 25% up the scale!???? ( This is whats worrying me.)
mark
very greatfull of your help
so what your saying when i have scaled my TPS raw it does not matter if any of my other TPS fuctions DONT go up on the scale? As they only go up about 25% up the scale!???? ( This is whats worrying me.)
mark
very greatfull of your help
Re: TPS switch
No your TPS signal does not have to match the tps to load table.
Scale your tps raw and you will be fine.
Hope this helps
Ed
Scale your tps raw and you will be fine.
Hope this helps
Ed