Wiring GEMS Anti Lag
Moderators:R!C0, JonMan, RickS
Hi there
I have a GEMS Plug in and play ecu fitted to a 95 WRX Impreza.How do wire the anti lag switch in.Any help much appreciated
Thanks
I have a GEMS Plug in and play ecu fitted to a 95 WRX Impreza.How do wire the anti lag switch in.Any help much appreciated
Thanks
Re: Wiring GEMS Anti Lag
hi there, its all in the manual which you can down load form this site
hope this helps
mark
hope this helps
mark
Re: Wiring GEMS Anti Lag
i have downloaded the manuals it doesnt show wiring dont suppose you have the link.darren
Re: Wiring GEMS Anti Lag
do you have a 4 or 3 plug ecu?
Re: Wiring GEMS Anti Lag
if its the 4 plug ecu then its the 2nd plug in from the right (smallest one) as you look as the ecu. you will see there is a top row and bottom row of wires. the one you want is on the bottom row and then its the 3rd wire in from the right. think its a green wire
hope this helps
hope this helps
Re: Wiring GEMS Anti Lag
Thanks very much for reply mate.Its the 4 pin type .So does that wire get cut and put a switch in between it
At the moment the engine is totally standard will it run ? Iam getting 440 injectors,uprated map sensor,upgraded fuel pump which came off the car the ecu did but there not coming until next week.
CheeRs
At the moment the engine is totally standard will it run ? Iam getting 440 injectors,uprated map sensor,upgraded fuel pump which came off the car the ecu did but there not coming until next week.
CheeRs
Re: Wiring GEMS Anti Lag
Had a look at the loom on my car today and pin B09 does not have a wire at it on my car loom iam told this is the pin for the anti lag switch.If i do run a wire from that pin does it just go to a switch and where does the other end go
Thanks
Thanks
Re: Wiring GEMS Anti Lag
Hi there,
Yes it does, Run a wire from this pin to the live pin onj the switch. Then run your second wire from the ground pin on the switch to an earth on the car.
Hope this helps.
Ed
Yes it does, Run a wire from this pin to the live pin onj the switch. Then run your second wire from the ground pin on the switch to an earth on the car.
Hope this helps.
Ed