Rev limiter for each gear

[WRC4ever]

Hi,

Evo 7, EEPROM Lancer8 S2.80. Is there a way to set the engine rev limiter to be different for each transmission gear?
I want, for example, to be able to go to 7500 RPM in 1st gear, whereas in 5th, say I want 6000.

Is this possible?

Thank you

Karl

[R!C0]

Hi Karl,

Sorry but is not a feature we have ever included in any of units. In some units you can set lights based on gear position but not the rev limit.

Regards

Rico

[WRC4ever]

Thank you for your prompt reply, Rico.

Regards,

Karl

[saintspall]

Hi Karl,

Sorry but is not a feature we have ever included in any of units. In some units you can set lights based on gear position but not the rev limit.

Regards

Rico

Hi Rico,how do i actually set the rev limit on the gwv4?

[R!C0]

Hi saintspall,

What ECU and version are you using?

[RickS]

Hi,

In the Lancer8 S2.80 the Rev limit can either be Fuel, ignition cut or a ignition retard limit. If you look in the tables in GWv4 you will find tables named.

Rev I Limit L table: Ignition cut based Rev Limit Vs TPS for Launch mode.
Rev I Limit N table: Ignition cut based rev limit Vs TPS for normal mode.
and Rev I Limit table: Ignition Cut based rev limit in Anti-lag mode.

Similarly the Rev F tables are fuel cuts and the Rev rtd's are ignition retards.

Hope this helps
Ed

[saintspall]

Hi,

In the Lancer8 S2.80 the Rev limit can either be Fuel, ignition cut or a ignition retard limit. If you look in the tables in GWv4 you will find tables named.

Rev I Limit L table: Ignition cut based Rev Limit Vs TPS for Launch mode.
Rev I Limit N table: Ignition cut based rev limit Vs TPS for normal mode.
and Rev I Limit table: Ignition Cut based rev limit in Anti-lag mode.

Similarly the Rev F tables are fuel cuts and the Rev rtd's are ignition retards.

Hope this helps
Ed

Its on a evo 9,so if i wanna adjust the rev cut i will just need to look at rev I Limit N table is that right?

[RickS]

Hi,

Yes, Thats right.

Ed