Old GEMSCOM software for MiniZeta G1.30

Post here if you have an issue with a GEMS Product

Moderators: R!C0, JonMan, RickS

Post Reply
divagomania
New User
Posts: 1
Joined: Sat Apr 05, 2014 8:53 am

Old GEMSCOM software for MiniZeta G1.30

Post by divagomania » Sat Apr 05, 2014 2:49 pm

I have a friend that is a recent owner of an 1983 Toyota already with a GEMS ECU MiniZeta G1.30. The old owner gave the cable to connect to it (RS232 to 4 pin connector) but had lost the software.


I have read in this forum that you have the GEMSCOM software for DOS available for free that could be enough to calibrate the ignition timing map. Is it possible for you to provide a copy of the GEMSCOM software?

The problem with the car seems to be a different cam timing to the ignition map programmed in the MiniZeta G1.30 ECU.

Thank you

User avatar
RickS
GEMS Engineer
GEMS Engineer
Posts: 542
Joined: Thu May 17, 2007 11:38 am

Re: Old GEMSCOM software for MiniZeta G1.30

Post by RickS » Mon Apr 07, 2014 8:22 am

Replied via email.......

Hi,
I will try to locate some info for you but apparently we charge £75 for GEMSCOM as we have to build a setup for you as it is no longer readily available. However, where the 'free' idea comes from is that the software is not protected, so if you find someone with a version, you can copy it from them 'for free'.
BR
Rick

Post Reply