EM36 output testing
Moderators:R!C0, JonMan, RickS
Good afternoon,
from the instruction manual I can see this great unit can send output codes to test connected items, i.e injectors or solenoids etc, but dont really understand how or where to put the GEMSCOM codes in to send the signals, can anyone provide an quick over view to help me along ?
regards
Mark
from the instruction manual I can see this great unit can send output codes to test connected items, i.e injectors or solenoids etc, but dont really understand how or where to put the GEMSCOM codes in to send the signals, can anyone provide an quick over view to help me along ?
regards
Mark
Re: EM36 output testing
Hello,
Re you refering to the 'testing' section of the manual? which version of EM36 are you running?
Thanks
Ed
Re you refering to the 'testing' section of the manual? which version of EM36 are you running?
Thanks
Ed
Re: EM36 output testing
Hi Ed,
My EM36 is on the latest software version, it was with you for a drive by wire upgrade last year and has had firmware changes for launch control by richard, Ive rear the testing section but to be honoust dont really understand the instructions about output testing, can you shed any light as a basic instruction?
everything else on the ECU is very user friendly ! !
Regards
Mark knight
My EM36 is on the latest software version, it was with you for a drive by wire upgrade last year and has had firmware changes for launch control by richard, Ive rear the testing section but to be honoust dont really understand the instructions about output testing, can you shed any light as a basic instruction?
everything else on the ECU is very user friendly ! !
Regards
Mark knight
Re: EM36 output testing
Dear Mark,
Ah yes i remember it, good to hear from you again. The testing section really shouldn'tbe in the manual as it is a last resort and should only be used by us. It allows us to pulse any output, Such as injectors at a 50% duty cycle (i.e. Half of the time it's on and half of the time it's off) so that we can check it's working with an oscillascope or multimeter with duty cycle on it.
Do you require testing the outputs? Thankyou for you positive coments on the EM36.
Ed
Ah yes i remember it, good to hear from you again. The testing section really shouldn'tbe in the manual as it is a last resort and should only be used by us. It allows us to pulse any output, Such as injectors at a 50% duty cycle (i.e. Half of the time it's on and half of the time it's off) so that we can check it's working with an oscillascope or multimeter with duty cycle on it.
Do you require testing the outputs? Thankyou for you positive coments on the EM36.
Ed