Page 1 of 1

dyno tuning

Posted: Sat Nov 07, 2015 2:54 pm
by jptrapezio
I have Gems plug and play engine management for a Subaru STI with a N 14 tuning( Terry Stamper) and I am replacing the injectors(bigger) and fuel pressure regulator ,I need a dyno tuning the only problem is that I live in the South east part of the USA . Do you have anyone that could tune my car ?

Re: dyno tuning

Posted: Mon Nov 09, 2015 9:08 am
by RickS
If you have a look at the 'Re-sellers' section of our website, there are a couple of US of A address' who might be able to help find you somebody to dyno the car but nobody directly in the SE.

There might be some mileage in contacting Terry, as he travels world-wide to tune customers cars.

Best regards,
RickS

Re: dyno tuning

Posted: Fri Nov 13, 2015 1:38 am
by jptrapezio
thanks for your answer , I've contacted Terry Stamper for another problem that I have with the ALS setting. But this is a problem to find a tuner in the USA for a Gems engine management ...I might not replace my injectors looks to complicated for the tuning when you don't know too much about it. I need to calibrate the gas pedal and try to find out what is wrong with the ALS :when ALS on at start on 1 gear launch the car and RPM goes above 5000 engine dies like I've got no gas then I turn off the ALS and engine starts back on do you have any idea what is going on?
best regards
Jean Pierre

Re: dyno tuning

Posted: Mon Nov 16, 2015 10:08 am
by RickS
Not without looking at the calibration that is installed in the ECU unfortunately.

If you have (or can extract) the .CAL file from the ECU, send it to the Tech.Support email address of the gems.co.uk website and I will be able to see how your calibration is set and maybe then we will be able to make some suggestions. What you could check first of all, are the Fuel/Spark/Retard tables for the ALS mode that you are using (Full or Mild), to see if there is a limit of 5000 specified in any of them, especially 'fuel'.

Has this always been a problem or has it just started..? Please reply to the tech.support email address for gems.co.uk.