GEMS EVO X tacho pin out

Questions relalting to all engine GEMS ECUs

Moderators:R!C0, JonMan, RickS

Locked
User avatar
RickS
GEMS Engineer
GEMS Engineer
Posts:547
Joined:Thu May 17, 2007 11:38 am
GEMS EVO X tacho pin out

Post by RickS » Tue Jun 26, 2012 8:10 am

On the Mitsubishi EVO X GEMS ECU, can I connect a tachometer to the Pin 100, the defined tacho output?

How many pulses per rev will this pin do?

On our engine cal the tacho pin is set to 255, can I set it to 100? Or is this being used for something else?

Best regards

User avatar
RickS
GEMS Engineer
GEMS Engineer
Posts:547
Joined:Thu May 17, 2007 11:38 am

Re: GEMS EVO X tacho pin out

Post by RickS » Tue Jun 26, 2012 8:14 am

Set Tacho_Pin = 8, but 255 will also work.
It is possible to use serial TX as tacho but not recommended.
Then the Tacho_Edge table defines where transitions occur relative to crank teeth.

It is better to use 2nd CANbus, or just piggy back dash on main CANbus.

Locked