Cannot connect to my ecu
Posted: Tue Jan 22, 2008 11:35 am
- The ECU goes into a Data stream mode after 2 Seconds and will not be able to communicate when in that mode. To avoid this happening, click connected before switching on the ignition.
- Check Baud Rate is set to 38400. In GWv3 goto ECU > Baud Rate.
- Check correct Communication port is selected. You can select the connection port in GWv3 under: ECU > Connection Port. If you connecting using the serial port this is usually COM1. If you are using a USB to serial converter then the name of the conveter i.e. ATEN USB will appear in the list.
- Check Baud Rate is set to 38400. In GWv3 goto ECU > Baud Rate.
- Check correct Communication port is selected. You can select the connection port in GWv3 under: ECU > Connection Port. If you connecting using the serial port this is usually COM1. If you are using a USB to serial converter then the name of the conveter i.e. ATEN USB will appear in the list.