Can't connect to my ECU.

Mitsubishi EVO plug n play ECU FAQ's

Moderators:R!C0, JonMan, RickS

Locked
R!C0
Site Admin
Site Admin
Posts:230
Joined:Thu May 10, 2007 1:21 pm
Can't connect to my ECU.

Post by R!C0 » Tue Jan 22, 2008 11:29 am

- The ECU goes into a Data stream mode after 2 Seconds and will not be able to communicate when in that mode. To avoid this happening, click connected before switching on the ignition.

- Check Baud Rate is set to 38400. In GWv3 goto ECU > Baud Rate.

- Check correct Communication port is selected. You can select the connection port in GWv3 under: ECU > Connection Port. If you connecting using the serial port this is usually COM1. If you are using a USB to serial converter then the name of the conveter i.e. ATEN USB will appear in the list.

Locked